0

Installed slackware11 on KVM, which is controlled by virt-manager. I need one more network interface, so I added another one using the same model as was installed by default, and restarted the machine. But the ifconfig command just shows the lo and eth0.

Should I do any job on Linux after adding interfaces to KVM?

0

1 Answer 1

2

Running ifconfig itself provides only a list of interfaces which are up, i.e. interfaces which are somehow already configured.

To see all the interfaces use ifconfig -a or ip address show

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .