0

I am trying to install QNX 6 from CD. I formatted the entire hard drive using cfdisk as "QNX 6 filesystem", but I still get the error message "No QNX 6.1 filesystem or greater available to mount".

Any idea how I can fix this error?

3
  • QNX 6 is over 20 years old. R u sure it supports your storage controller? Dec 30, 2022 at 22:26
  • My hardware is almost as old. Is there any way to check if it is supported?
    – Village
    Dec 31, 2022 at 15:47
  • QNX6 is barely functional nowadays, you could test it in a VM instead. Dec 31, 2022 at 22:32

1 Answer 1

3

cfdisk only operates on the partition table and its partition type codes. It will not actually create any filesystem structures within the partition, especially not for such an obscure/legacy filesystem.

You'll need a separate mkfs tool to actually create ("format") the filesystem. Unfortunately I have no idea where such a tool could be found.

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .