Goal: Configure Ubuntu and Firefox to SSH into a remote Asus router and access the remote router's configuration GUI via Firefox.

top from the remote router returns:

22984   493  user    S     1132  0.4   0  0.0 dropbear -p 22 -j -k

The remote router is configured with openssh-sftp-server and Merlin-Asus firmware:

ipkg list_installed | grep  ssh


openssh-sftp-server - 5.9p1-1 - sftp-server only from a FREE version 

of the SSH protocol suite of network connectivity tools.

Ubuntu SSH Dynamic Port Forwarding is created with:

ssh -D localhost:3000 [email protected]

Firefox proxy configuration:

enter image description here

The tunnel is tested with http://www.whatismyip.com, however, the test fails to return a webpage. These error messages are observed in the BASH console:

channel 3: open failed: administratively prohibited: 
channel 4: open failed: administratively prohibited: 
channel 5: open failed: administratively prohibited: 
channel 6: open failed: administratively prohibited: 


  • Is the tunnel correctly configured from the command line?
  • Is the tunnel correctly configured within Firefox?
  • What tests can be performed to confirm the issue?

Diagnostic questions and any actionable guidance to reach the goal is appreciated.

UPDATE: TL\DR see answer below.


2 Answers 2


If your objective is to access the router configuration GUI on the same router you are running ssh (dropbear) on, then you are not looking for socks proxy, but for local port forwarding.

Set up the ssh tunnel on the Firefox host (assuming your web UI serves on port 80):

ssh -L 3000:localhost:80 [email protected]

and point Firefox to http://localhost:3000.

(Note for better understanding: localhost in above command is relative to your router, i.e. the ssh server forwards to localhost:80 from its local context.)

What this does is open local port 3000 and tunnel it through an established ssh connection to the router and connect it to the service running on port 80 on the router.

EDIT: you have to additionally make sure dropbear runs with the -a option to allow port forwarding. (See dropbear options.) This can be achieved in the web UI as shown in this answer



  • 1
    Thanks for the reply: I tried invoking ssh -L (local port forwarding) as described above but received the same failure messages in the original post. Have you had success with Ubuntu / Firefox? What can be done to diagnose my error? Thank you
    – gatorback
    Feb 22, 2020 at 14:19
  • How can I test / verify that port 80 is the proper choice?
    – gatorback
    Feb 22, 2020 at 14:34
  • @gatorback: if on your LAN (same network as your router) you can login to its web UI with firefox without specifying the port (i.e. http://myrouter), then it's running at port 80.
    – ppenguin
    Feb 22, 2020 at 14:37
  • @gatorback: just edited answer, hope the -a option to dropbear gets rid of the forwarding errors...
    – ppenguin
    Feb 22, 2020 at 14:45
  • Your postings & tips have been helpful to make incremental progress to the point where I am now able to access router's GUI
    – gatorback
    Feb 22, 2020 at 22:42

SSH Dynamic Port Forwarding was correctly configured. To accomplish the goal, the Asus router has a setting that permits SSH port forwarding, which must be enabled:

enter image description here

ppenguin advises: For extra security consider adding/updating an authorized_keys file (usually in /root/.ssh/authorized_keys) containing your public key. After you tested you can login without a password (with your public/private key pair) turn off Allow Password Login.

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .