0

Redis installed and looks to be running:

[me@hsredistest01 ~]$ sudo systemctl status redis
● redis.service - Redis persistent key-value database
   Loaded: loaded (/usr/lib/systemd/system/redis.service; enabled; vendor preset: disabled)
  Drop-In: /etc/systemd/system/redis.service.d
           └─limit.conf
   Active: active (running) since Mon 2019-04-22 19:03:35 +03; 34min ago
 Main PID: 8780 (redis-server)
   CGroup: /system.slice/redis.service
           └─8780 /usr/bin/redis-server 127.0.0.1:6379

It says running port 6379 here, but when I scan the running service ports I can't see it.

[me@hsredistest01 ~]$ sudo nmap -sT -O localhost

Starting Nmap 6.40 ( http://nmap.org ) at 2019-04-22 19:40 +03
Nmap scan report for localhost (127.0.0.1)
Host is up (0.000078s latency).
Other addresses for localhost (not scanned): 127.0.0.1
Not shown: 996 closed ports
PORT    STATE SERVICE
22/tcp  open  ssh
25/tcp  open  smtp
111/tcp open  rpcbind
199/tcp open  smux
Device type: general purpose
Running: Linux 3.X
OS CPE: cpe:/o:linux:linux_kernel:3
OS details: Linux 3.7 - 3.9
Network Distance: 0 hops

OS detection performed. Please report any incorrect results at http://nmap.org/submit/ .
Nmap done: 1 IP address (1 host up) scanned in 1.73 seconds

I just want to type 192.168.0.23:6370 in browser and see something like Redis is fine message.

  • Redis is configured to listen on localhost by default because of security reasons. You could need to alter redis conf in /etc first and restaet the service – Sergiy Kolodyazhnyy Apr 22 at 17:46
  • @SergiyKolodyazhnyy hello yes you are right, can you check this link as well about that topic please; unix.stackexchange.com/questions/513908/… – Y3N3RRR Apr 22 at 22:19
2

You did not run a nmap scan that would reach port 6379, the default is to only scan 1000 of the most common open ports.

You can pass a single port to nmap: nmap -p 6379 -sT -O localhost

or you can pass a range of ports: nmap -p 1-65535 -sT -O localhost

The more ports scanned, the longer it will take.

Also, make sure your firewall allows connections to the port or nmap will not see it.

  • While it is correct about nmap, redis config is also something to consider. See my comment under question – Sergiy Kolodyazhnyy Apr 22 at 17:48

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.