0

I'm getting this error occasionally when my device wakes up from suspend,

iwlwifi: Log capacity -1515870811 is bogus, limit to 1 entries
iwlwifi: Log write index -1515870811 is bogus, limit to 1
iwlwifi: Start IWL Event Log Dump: display last 1 entries
wlp3s0: HW problem - can not stop rx aggregation for 9c:1c:12:24:0e:18 tid 0
iwlwifi: Command REPLY_ADD_STA failed: FW Error
wlp3s0: HW problem - can not stop rx aggregation for 9c:1c:12:24:0e:18 tid 1
p3s0: CTRL-EVENT-DISCONNECTED bssid=9c:1c:12:24:0e:18 reason=4 locally_generated=1
arn>  [1530059866.2378] sup-iface[0x5575dbb13da0,wlp3s0]: connection disconnected (reason -4)
ieee80211 phy0: Hardware restart was requested

... lots of stuff and a stack track

iwlwifi  iwl_trans_wait_tx_queues_empty bad state = 0
iwlwifi: Radio type=0x1-0x2-0x0
iwlwifi: Could not load the [0] uCode section
iwlwifi: Failed to run INIT ucode: -5
iwlwifi: Unable to initialize device.

... another stack trace,

I'm using this Wifi Card in a Lenovo x230 (from lspci, and syslog)

Network controller: Intel Corporation Centrino Advanced-N 6205 [Taylor Peak] (rev 34)
iwlwifi: Detected Intel(R) Centrino(R) Advanced-N 6205 AGN, REV=0xB0

I see a lot of errors pertaining to this card, but not with a failure to load uCode (microcode?) When things work, I see this in my syslog,

iwlwifi: can't disable ASPM; OS doesn't have ASPM control
iwlwifi: loaded firmware version 18.168.6.1 op_mode iwldvm

According to the official Linux Wireless wiki, I am running the latest version (18.168.6.1).

From all syslog messages PCI Address (0000:03:00.0) and timestamps cut out.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.