On Arch Linux. Had netctl managing my connections, had internet access, switched to connman (installed connman, disabled netctl service).

Followed instructions on the wiki, connected to wifi network, provided password, connman reports connected. However, I still have no internet access.

$ ping google.com
[...] Temporary failure in name resolution

$ ping
[...] Destination Host Unreachable
[...] Destination Host Unreachable

$ connmanctl state
State = ready
OfflineMode = False
SessionMode = False

$ ip addr
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet scope host lo
       valid_lft forever preferred_lft forever
    inet6 ::1/128 scope host 
       valid_lft forever preferred_lft forever
2: enp3s0: <NO-CARRIER,BROADCAST,MULTICAST,DYNAMIC,UP> mtu 1500 qdisc mq state DOWN group default qlen 1000
    link/ether 0c:54:a5:09:7e:fb brd ff:ff:ff:ff:ff:ff
3: wlp2s0: <BROADCAST,MULTICAST,DYNAMIC,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default qlen 1000
    link/ether 48:d2:24:06:33:0b brd ff:ff:ff:ff:ff:ff
    inet brd scope global wlp2s0
       valid_lft forever preferred_lft forever
    inet6 fe80::4ad2:24ff:fe06:330b/64 scope link 
       valid_lft forever preferred_lft forever

$ ip route
default dev wlp2s0 scope link dev wlp2s0 proto kernel scope link src 

closed as too broad by Ipor Sircer, G-Man, Jesse_b, Isaac, Yaron May 27 '18 at 12:56

Please edit the question to limit it to a specific problem with enough detail to identify an adequate answer. Avoid asking multiple distinct questions at once. See the How to Ask page for help clarifying this question. If this question can be reworded to fit the rules in the help center, please edit the question.

  • ip addr? ip route? – ajeh May 23 '18 at 20:40
  • @ajeh added to the question! – Daniel Nunes May 23 '18 at 20:56
  • Can you ping your hotspot/router? – ajeh May 23 '18 at 20:57
  • 1
    command not found but find / -name connman_resolvconf.conf gives no output. – Daniel Nunes May 23 '18 at 21:34
  • 1
    You are on a network which is different from your router network. Your local IP has to be in the 192.168.1.* network. – ajeh May 23 '18 at 21:50