1

So far I was trying to boot the HyperV VM from SMB share, it was failing with error "Remote SMB does not support resiliency". Finally I found that it only works with SMB2_02 protocol by adding below in smb.conf, 

max protocol = SMB2_02

So now I want to create an SMB share for this particular Hyper-V server with SMB2_02 and I don't want to affect other SMB configuration for other shares.

Will it be possible and how?

4
  • 1
    Another option may be to add an IP alias and tie two separate samba instances to separate IPs.
    – Jeff Schaller ♦
    Jan 17, 2018 at 10:55
  • @Jeff Schaller can you give me more details on this please
    – Dipak
    Jan 17, 2018 at 16:50
  • 1
    I don't have a way to test it, I'm just putting a possibility out there -- you'd (try to) configure each samba instance to listen only on its separate IP address; with separate config files, you could set the "max protocol" separately (in their Global sections)
    – Jeff Schaller ♦
    Jan 17, 2018 at 16:52
  • @Jeff Schaller it sounds cool to me, let me try this and I will update on this thread Thanks, I was in big trouble and now I see some hope on it :)
    – Dipak
    Jan 17, 2018 at 17:00

1 Answer 1

Reset to default
1

Not according to the documentation. max protocol is an alias for server max protocol, and that is defined as:

server max protocol (G)

... where the (G) means:

The letter G in parentheses indicates that a parameter is specific to the [global] section.

0

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .