2

I'm trying to figure out what kernel modules that I need to load in order correctly configure an TI OMAP3 based device (DM3730) as a USB host via the on-chip OTG controller.

Without loading any additional USB/gadget modules the OTG host controller does not recognize any USB devices when they are attached (no output in kernel ring buffer). I can successfully get the controller working by loading the g_zero module, but as I understand it this is a device testing and debugging driver only.

What modules would I need to load instead in order to allow the device to be configured in host only mode?

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.