1

I have an iwlwifi module installed and used as driver on my Lenovo ThinkPad s440 (Ubuntu 15.04). I also use NetworkManager for GUI setup which works perfectly till some point. But I found out that in one wifi spot I get two IP addresses connections. I.e. I can connect via lan cable to the same network and it works fine, but wlan0 shows connection and signal and packages transmission but no actual data transfer. I'm not a network guy, so do not completely understand network configuration, but here's the input:

lspci -k

04:00.0 Network controller: Intel Corporation Wireless 7260 (rev 73)
  Subsystem: Intel Corporation Wireless-N 7260
  Kernel driver in use: iwlwifi

dmesg | grep iwlwifi

774:[   13.321400] iwlwifi 0000:04:00.0: loaded firmware version 25.17.12.0 op_mode iwlmvm
775:[   13.885174] iwlwifi 0000:04:00.0: Detected Intel(R) Wireless N 7260, REV=0x144
776:[   13.885246] iwlwifi 0000:04:00.0: L1 Enabled - LTR Enabled
777:[   13.885484] iwlwifi 0000:04:00.0: L1 Enabled - LTR Enabled
977:[   43.279857] iwlwifi 0000:04:00.0: L1 Enabled - LTR Enabled
978:[   43.280100] iwlwifi 0000:04:00.0: L1 Enabled - LTR Enabled

iwconfig wlan0

wlan0     IEEE 802.11bgn  ESSID:"AhoyWatt"  
          Mode:Managed  Frequency:2.437 GHz  Access Point: 7C:0E:CE:3C:3B:90   
          Bit Rate=1 Mb/s   Tx-Power=22 dBm   
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Power Management:on
          Link Quality=26/70  Signal level=-84 dBm  
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:4  Invalid misc:77   Missed beacon:0

iw dev wlan0 link

Connected to 7c:0e:ce:3c:3c:38 (on wlan0)
  SSID: AhoyWatt
  freq: 2412
  RX: 1744900 bytes (9092 packets)
  TX: 11702 bytes (41 packets)
  signal: -32 dBm
  tx bitrate: 1.0 MBit/s

  bss flags:  short-slot-time
  dtim period:  2
  beacon int: 100

Could anyone suggest what's the problem why I can connect via cable and can't do this via wifi module exactly at this wifi spot ? One guy told me that I have two IP addresses assigned at the same time by iwl and NetworkManager and this is the conflict, but I do not understand why and what's the problem.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.