Next privilege 125 Rep.
Next badge 0/1
0 people reached
- 0 posts edited
- 0 helpful flags
- 1 votes cast
How can I mount partitons in a full disk image (i.e. image with partition table) with fuse?
Addition: it should also be possible to make a simple
How to configure external IP addresses for LXC guests?
I did approximately the same (except with a bit more manual setting up): netup script in each lxc config to add veth to the bridge (on the host), manual IP setup in each container, additional script / interface in each container to set up routing (via ip4 forwarding on host). But, as far as I see, both solutions mean that container can set own IP address to pretty much anything (and also adding the primary interface of the host to a bridge is slightly inconvenient). So I'm also interested in some feedback/solution.