1
vote
2answers
109 views

Retrieve value of RTS threshold without iwconfig

Is there a way in OpenWrt to read the current value of the RTS threshold for a specific interface without installing iwconfig? What I'm looking for is the value of RTS thr that can be found in the ...
0
votes
1answer
333 views

Wifi on/off button on TP-Link WR841ND

I installed OpenWRT into TP-Link WR841ND. Everything works as expected, but I can't get the wifi on/off switch working. I followed the guide described on the OpenWRT page for this router. Scripts in ...
1
vote
1answer
595 views

TP-Link TL-WR1043ND as dumb access point

I followed these instructions on how to set up my TP-Link TL-WR1043ND as a dumb AP: Flashed brand new Attitude Adjustment 12.09-rc1 Logged into LuCI, set up a password Disabled and stopped firewall ...
3
votes
1answer
2k views

The n mode on “iwlist wlan0 scan”

I know how to determine if scanned AP uses B or G mode, but how to know (using "iwlist wlan0 scan") it uses N protocol ? if I use "iw dev wlan0 scan" and see if the cell has a "HT capabilities" block. ...
8
votes
1answer
2k views

Linux find Wifi Networks trotocol(a/b/g/n) version of all available access points

I do use iwlist wlan0 scanning and it gives me a fair amount of data, but one part is missing. It is protocol version. By protocol I mean (a/b/g/n). It would be very good to have these commands in ...
3
votes
1answer
6k views

Configure OpenWRT as repeater

At home I'd like to configure one of my wifi routers to serve as a WI-FI signal extender. Since my main router is OpenWrt-based (Backfire 10.1.3), I'd like to use it for that purpose. I've looked ...
4
votes
1answer
6k views

How to extend my wireless network with OpenWrt

I have two routers, both running OpenWRT 10.04 The first is a WRT160NL router connected to my ISP. I am using it as an access point with the ESSID of "160AP". It's WEP password is "AAAAA" and it's ...