1
vote
1answer
25 views

Clone installed system by using the hardware RAID 0+1 synchronization

Alright, following setup: 2 identical machines (DELL Power Edge T320) with a hardware raid. one machine is running for a while now, one machine hasn't even been set up at all The running machine ...
0
votes
1answer
40 views

RAID Level 5 versus Level 1

Is it slower to write one block in RAID Level 5 with 5 disks than RAID 1 with two disks (mirroring only)? I think No since with Level 5 you are writing the data and the parity (two writes). With Level ...
3
votes
1answer
52 views

Recover data from raid 1 when both drives are faulty

I had a RAID 1 on my server, and apparently both of hard drives have failed at the same time. Server support did a quick check to confirm that HDDTEST-W1F21M6K ERROR Finished (Selftest, Device: ...
2
votes
1answer
667 views

Mount an existing RAID 1 Logical Volume after OS upgrade

I just upgraded from Ubuntu 10.04 to Mint 16. The installer did not detect my existing RAID 1 array, and I can't access it anymore. My drives are: SDA - First RAID Disk SDB - Second RAID Disk SDC - ...
2
votes
2answers
145 views

Are disks interchangeable in a mirrored RAID setup?

It is often written that disks in a mirrored RAID (like RAID 1) are an exact mirror copy one of another. So can I turn the machine off and simply swap the two harddisks cables? And if one of the two ...
0
votes
2answers
433 views

Can disks be accessed independently in a RAID-1 volume?

I want to create a RAID-1 array with Debian 6. This array will contain 6 disks, 3 for the OS and 3 mirrors. I used this RAID before but on windows, and maybe I didn't do it good at all, because I ...
1
vote
1answer
208 views

How to rebuild a two drive raid 1 array on Linux?

I need to rebuild a two drive (160x2) raid 1 (mirror) array. It was an Intel raid from a 7 year old Dell computer (Windows). Both drives are assumed to be functioning. The raid was created with an ...
1
vote
2answers
355 views

Can't remount local file systems for read-write (RAID1)

I assembled a new machine on Asus P9X79 motherboard, using its RAID controller to create a RAID1 array of two 500Gb drives. When booting Arch from an external drive I am able to work fine with ...
2
votes
1answer
3k views

How to set up disk mirroring (RAID-1)

I have a computer with two WD 1TB drives and I want to configure disk mirroring on it. I tried setting up RAID during the installation by creating RAID partitions but that does not work for me. Is ...
3
votes
2answers
140 views

RAID Lag-Behind Burst Write

I would like to setup RAID1 so that a ramdisk in the RAID configuration has occasional synchronisation with a physical disk (that is very battery intensive to run, so I hope to let it spinout). Is ...
4
votes
1answer
2k views

Why does btrfs allow to create a raid1 with mismatched drives?

I'm creating a btrfs using sudo mkfs.btrfs -m raid1 -d raid1 <small-disk> <large-disk> or sudo mkfs.btrfs -m raid1 -d raid1 <large-disk> <small-disk> it creates the fs with ...