2
votes
1answer
16 views

How to flash a router from FreeWRT to OpenWrt?

How can I change the firmware on a router from FreeWRT to OpenWrt? The router is a Linksys WRT54GL, so it should have enough memory for OpenWrt and I have SSH connection as root to the system.
0
votes
0answers
15 views

How to disable domain service at port 53 on WAN side in OpenWRT?

nmap on the WAN IP shows PORT STATE SERVICE 53/tcp open domain after basic configuration on a fresh OpenWRT (version Chaos Calmer) system. But the service should not be visible from WAN, but ...
0
votes
1answer
416 views

Wifi on/off button on TP-Link WR841ND

I installed OpenWRT into TP-Link WR841ND. Everything works as expected, but I can't get the wifi on/off switch working. I followed the guide described on the OpenWRT page for this router. Scripts in ...
1
vote
1answer
456 views

Imagemagick on open wrt router “UnableToOpenConfigureFile”

I have installed Open Wrt on my TP-Link TL-WR740N/ND v4. Everything works fine but the Imagemagick. I have installed it into ram (no enough space on rom ) with opkg # opkg install imagemagick ...
2
votes
0answers
1k views

How to setup PPPoE with OpenWrt

Probably this is a simple question, but I can't find an answer... I have an ADSL router (Dlink DSL-524T) which runs OpenWrt Backfire 10.03.1. It connects to the internet using PPPoA: this is my ...
1
vote
1answer
643 views

TP-Link TL-WR1043ND as dumb access point

I followed these instructions on how to set up my TP-Link TL-WR1043ND as a dumb AP: Flashed brand new Attitude Adjustment 12.09-rc1 Logged into LuCI, set up a password Disabled and stopped firewall ...
0
votes
3answers
2k views

How to make sense of an iptables chain configuration

This is about how to make sense of the chains found in the iptables default configuration on a typical home router running OpenWrt (a stripped down Linux for router devices), but which ultimately may ...
2
votes
1answer
851 views

Allow IP packet forwarding from LAN to modem via router

In short: I'd like to be able to telnet to my modem from my PC via my router. There is a simple home router on 192.168.33.1. It is running OpenWrt. It has the following interfaces defined: br-lan ...
2
votes
2answers
3k views

Force to use specific DNS provider at network

OpenDNS offers a quite simple way for internet filtering by categories. Of course who could get the correct IP address can easily bypass the filter but it would be enough for my expectations. The ...