1
vote
1answer
14 views

Naming PPP interfaces

I have two PPP peers, dsl-line1 and dsl-line2 which are configured with pppd on Ubuntu (Server) Linux. They are brought up by the /etc/network/interfaces file with the auto thingy however each PPP ...
1
vote
2answers
51 views

No eth0 after HD transplant

After moving the hard drive of a makeshift server to another compatible hardware (64-bit, same processor "generation", laptop->desktop) configuration, networking fails to initiate. Specifically: ...
0
votes
2answers
23 views

vnstat not updating

I installed vnstat on my Ubuntu 14.04 server to track my internet usage (I have a limited monthly transfer). The database never updates, however. I've tried uninstalling/reinstalling, but that doesn't ...
2
votes
1answer
38 views

Traffic segmentation for a particular subnet

Two questions is it possible to segment traffic for a particular subnet to use an interface and at the same time receive traffic from a different subnet via the same interface? This is the scenario. ...
2
votes
1answer
26 views

Lubuntu IP conflict [closed]

I have this friend who recently installed Lubuntu on his Asus Netbook to try it out. Problem is that even though he can find all network connections and after trying to connect to two of them (giving ...
1
vote
1answer
18 views

Interface Priority in the Face of VPN

I have a few interfaces: wlan0, eth0, lo, and sometimes tun0. When I connect to the Juniper VPN, creating a tun0 interface, my existing connections on other interfaces (perhaps with the exception of ...
0
votes
1answer
63 views

Consistent network interface name ubuntu using pci slot

One can set consistent interface naming via mac address by modifying /etc/udev/rules.d/70-persistent-net.rules. Can you establish consistent interface naming by PCI slot number? (I tried but failed) ...
3
votes
0answers
82 views

Ubuntu eth0 not detected

After installing a new version of this distro, eth0 is not detected automatically. command inxi -SNxz result: Network: Card-1: Broadcom NetXtreme BCM57786 Gigabit Ethernet PCIe bus-ID: 01:00.0 ...
0
votes
0answers
22 views

How can I make CentOS 6 treating WiFi flexibly like Ubuntu 12.04?

In my office, I have AT&T Uverse. The router is a 2wire 3600HGV. The WiFI is provided by a Cisco Linksys E1000 that is plugged in the 2wire device. With my notebook running Ubuntu 12.04 LTS ...
1
vote
1answer
64 views

ssh ubuntu to android : No route to host

I am trying to log into my android phone (running sshdroid), using my laptop (ubuntu 12.04). I am on a university sub-network (on wifi), and so is my phone. I tried the following command: ssh ...
1
vote
1answer
32 views

DHCP Problems Virtualbox

I have some minor issues with Ubuntu server on a virtual machine and even though I have some assumptions as to what actually happens, I'd like to ask all of you about your opinion. Here's the deal: I ...
3
votes
0answers
89 views

Linux - Only first virtual interface can ping external gateway

I created 3 virtual interfaces with different MAC addresses all linked to the same physical interface. I see that they can successfully arp for the gateway (gw) and they can ping (the request is ...
-4
votes
1answer
94 views

How do I know all IP related to the wireless LAN in ubuntu 14.04? [duplicate]

How I know all IP on my LAN Wireless using ubuntu 14.04
0
votes
0answers
31 views

Ubuntu + CISCO VPNC CLIENT for my new ubuntu version (32 bit )

I have newest Ubuntu Linux version 10.04.4 (32 bit ) I want to install Cisco VPNC client on this linux machines in order to connect to other customers I little confuse , which VPNC cisco version ...
2
votes
2answers
75 views

Different sites on different interfaces using link aggregation

I read about Ubuntu Bonding and how it allows to bond multiple connections to get several advantages. My requirements is this : I want two different interfaces at a time (A wifi and other Ethernet) ...
0
votes
1answer
55 views

Unidentified network connections

I have an external-facing ftp/webserver (with virtual hosts) running Ubuntu 12.04LTS, and I have some concerns about some network traffic I'm seeing. Some background. I tried to be as preventive in ...
2
votes
1answer
80 views

How to make HA Heartbeat failover when either of two NICs connection is lost?

I was successful in configuring a simple Heartbeat setup on Ubuntu 12.04, which will fail-over two VIPs to a second server when BOTH Ethernet links fail. What I can't figure out is how to fail-over ...
2
votes
1answer
130 views

How to check what `wondershaper` has done?

I used this command: sudo wondershaper eth1 20 20 to limit network traffic. The command shows no errors. But I need a command or network monitor or gui which confirms this limitation. For example, ...
1
vote
1answer
75 views

Does a Virtual Machine Server Have a Web address? [closed]

Hi I'm trying to set up a server for my moodle virtual programming lab. It has something named a jail server that is used to run code remotely. I have a Ubuntu server set up with all the correct ...
2
votes
1answer
154 views

Configure guessnet to switch automatically between LAN and WLAN

I want to configure guessnet and wpa_supplicant such that if I plug in my LAN cable, it connect to the network via the cable and if I unplug it, it automatically switches to WLAN and vice versa. I ...
2
votes
1answer
331 views

How to enable two network interfaces both for internet in ubuntu12.04

My physical server A has two interfaces: eth0 and eth1. I intend to enable the two network interfaces both for internet in ubuntu12.04. I configure the /etc/network/interfaces as below: auto lo iface ...
2
votes
2answers
816 views

Configure multiple interfaces with different hostnames using DHCP and DNS

I have a machine running Ubuntu 12.04 Server with two interfaces connected (eth0, eth1) to the network. Our network is set up so that a FreeBSD based DHCP server hands out leases and registers the ...
4
votes
1answer
2k views

How to permanently disable a network interface?

I've brought down a network interface with ifconfig wlan0 down, but every few hours or so, the wlan0 interface comes back up and I can't figure out why. I don't restart the machine, never changed ...
1
vote
1answer
61 views

MAC Address changes after dirty shutdown

I'm having a strange issue which I originally thought was tied to the fact that I created an Ubuntu system from an image of another. However, after reinstalling Ubuntu from scratch I am getting the ...
3
votes
1answer
3k views

Cloned Linux system and /etc/udev/rules.d/70-persistent-net.rules

I set up an Ubuntu system and configured it properly, including defining eth0 in /etc/network/interfaces. I then imaged that system and cloned it on a new system. When I booted up the system the ...
0
votes
0answers
352 views

OpenSSH hangs after login without showing login prompt

I ran across an issue with ssh after fresh Ubuntu 13.10 installation on Lenovo T420. I tried git pull (which failed) and this led me to more general ssh failing. After spending some 2-3 hrs of ...
-3
votes
3answers
151 views

Configure eth1 to stop using dhcp [closed]

How do I configure eth1 (via terminal commands) to stop using DHCP. That is, if I had the ability to use the GUI, I would select the MANUAL setting.
0
votes
1answer
2k views

Ubuntu: how do you swap eth0 and eth1? (Ubuntu 13.10 server in a VirtualBox VM)

I installed Ubuntu 13.10 server (64-bit) in a VirtualBox 4.3.6 VM (Windows host) with one NAT adapter assigned. The only non-default software selected during installation was OpenSSH. So far so ...
1
vote
1answer
53 views

Does my VM need to be on the same LAN IP range to ping?

I have a home LAN where all internal IP addresses are in the rang 192.169.0.0-254. However, on one of those computers I have setup a CentOS VM, which currently seems to be set to 10.0.2.1. So the VM ...
4
votes
4answers
220 views

How to show network adapters with their statistics?

Is there any terminal command I can use to display all the network adapters like eth0, wlanoand their data statistics like data transmitted & received?
5
votes
1answer
740 views

Wi-Fi with WEP from command line in Ubuntu 12.04, Kernel 3.8.0-29-generic

I have removed network-manager and am trying to configure Wi-Fi with WEP manually. I am running on an X1 Carbon. Here are the commands I am running: ifconfig wlan0 down iwconfig wlan0 essid ...
0
votes
0answers
149 views

Access devices on a shared internet connection from other devices on home network (Ubuntu, shared wireless to ethernet)

Laptop OS: XUbuntu 12.04 Home PC: XUbuntu 12.04 guest on Windows 7 host Embedded Things: Mix of Raspberry Pis or Beaglebones I'm trying to share the wireless connection on a laptop with multiple ...
2
votes
1answer
2k views

Firefox: use system proxy settings, but where are these?

Running Ubuntu 13.10, Firefox is configured to use the system proxy settings, but it seems it fails to pick them up. The computer is connected to the network, and it's possible to establish a ...
0
votes
1answer
82 views

why gentoo livecd can not detect the linked network card?

The original os is Ubuntu 12.04, machine has 4 network cards, and the first netcard is linked. If use ethtool, will get Link detected: yes. When I use gentoo livecd to start, and config network, I ...
0
votes
0answers
65 views

Network connecting trouble shooting

I am trying to connect to the network of my school. With Windows 7 + IE it is not problem at all. I connect to it, no matter what web-page I try to reach, I get forwarded to ...
2
votes
3answers
624 views

/usr/bin/host not picking up changes to /etc/hosts even after reboot

I have a Ubuntu Server 12.04 (amd64) machine on which, when I change /etc/hosts, the changes aren't picked up, even after a reboot. I am using /usr/bin/host to test, but none of the other programs ...
0
votes
3answers
96 views

Why do two Ubuntu systems in the same network behave differently in DNS resolution?

I have two systems, both running Ubuntu 12.04, which are within the same network (connected by hubs without routing logic). Both systems are configured quite similar, but not identical. In particular, ...
2
votes
1answer
31 views

Ubuntu blocks access to services when not logged in

I'm not really sure what's going on here. I have the following: A fresh install of Ubuntu 12.04 LTS. Jira 6.1.2 installed as per instructions from Atlassian. Confluence 3.5.13 installed as per ...
0
votes
1answer
154 views

network device name is changed by itself

I use a Ubuntu-arm, uname -a Linux arm 3.7.8-x8 #1 SMP Sat Feb 16 04:15:13 UTC 2013 armv7l armv7l armv7l GNU/Linux I have two USB WiFi interfaces that are named wlan0 and wlan1 on ...
1
vote
0answers
128 views

Local Server not accessible on Linux

My Internet company set up a local server, where different files are hosted. I can download files at much higher speed from there. But for some reason, the server is not accessible from Ubuntu 13.10 I ...
0
votes
0answers
82 views

Local servers (behind NAT) on vpn with email servers and sync with a central email server open to internet

What I have I have a number of Linux (Ubuntu) servers (20 as of now but may grow over time to hundreds) connected to each other via private VPN (OpenVPN) which serve intranet web application (Apache ...
2
votes
1answer
106 views

Mark packets between machines (client and router)?

Can I mark a packet on the client's OUTPUT chain and add an iproute policy on the router to route them via a specific gateway? This what I tried to do, but it isn't working. My client's mangle table ...
4
votes
1answer
442 views

How can I secure my Ubuntu 13.04 to prevent network attacks? [closed]

Is there a way I could protect my pc computer from being hacked in an event where the internet conection will be opened? Thing is I am going to Campus Party Colombia 2013 and I was sugested to format ...
2
votes
1answer
396 views

Execute custom script when an interface gets connected

I using a USB wifi dongle to connect to the Internet. When the wireless connection dies, I lose some iproute rules too. How can I reset these rules when the interface connected again?
1
vote
1answer
108 views

OpenVZ bridged networked adapters won't work from sample configs

I've made a copy of the basic config and added the line: NETIF="ifname=eth0,bridge=br0" When I create a new machine and enter it I can't make the network adapter work yet creating an instance from ...
4
votes
1answer
190 views

NetworkManager connection sharing doesn't seem to NAT packets

After setting up network sharing the easy way on the Ubuntu machine, and getting an IP address via DHCP on the Arch Linux machine downstream, the Arch machine is able to ssh to the Ubuntu machine and ...
1
vote
2answers
224 views

VNC connection taking a long time to connect (essentially…never)

I have my Ubuntu 13.10 desktop with vnc setup and installed. I'm using both a Macbook's integrated vnc remote desktop program and Windows 7's built-in Remote Desktop program to vnc. Both give the same ...
2
votes
0answers
25 views

Route a particular process over another gateway [duplicate]

I have 2 internet connections on differnet interfaces. I have eth0 which is internal ip of 192.168.1.70 and then I have another network connection to a different network which is on wlan0 ...
1
vote
1answer
1k views

How do I generate an SNMP community string for MRTG?

I have trying to set up MRTG on my server, following this guide: https://help.ubuntu.com/community/MRTG I followed it as far as, cfgmaker ...
0
votes
2answers
136 views

How to attach my domain with bind in real www

How to attach my domain with bind in real wwwI install bind9, with apache. By God's very grace every thing went smooth. my dig, host, nslookup and ping provide this info: my system ip address: ...