Netcat is a computer networking service for reading from and writing network connections using TCP or UDP

learn more… | top users | synonyms

23
votes
2answers
19k views

/dev/tcp listen instead of nc listen

With a netcat listener like: nc -l <port> < ~/.bashrc I can grab my .bashrc on a new machine (doesn't have nc or LDAP) with: cat < /dev/tcp/<ip>/<port> > ~/.bashrc My ...
12
votes
1answer
8k views

Remote desktop over SSH reverse tunnel to replace TeamViewer

I want to open a remote desktop session from my laptop to desktop over my SSH (reverse) tunnel. That should be simple (or at least doable), right? Until now I've been using Team Viewer to log in to ...
11
votes
3answers
10k views

Using in/out named pipes for a TCP connection

I've been fiddling with getting this to work for a while now, so I suspect some sort of fundamental misunderstanding about how pipes work is the root cause of my troubles. My goal is to initiate a ...
2
votes
1answer
326 views

Jumping ssh hosts without netcat

I have access to an intermediate server to which I can connect with ssh. From there I can connect to other servers: A→B→C, where A is my laptop, B is an intermediate server accepting connections from ...
1
vote
2answers
155 views

Capturing data from a Fluke 1620a via netcat

I am trying to pull temperature and humidity data from Fluke DewK 1620a thermo-hygrometers and write the temp/humidity readings to a log. I can connect to the device via netcat with a simple 'nc 1.2.3....
1
vote
1answer
3k views

netcat echo server - possible with pipes instead of commands as strings?

I want to create an echo server without specifying any of my commands inside strings. I want all commands to be connected by pipes. This doesn't appear possible because the response gets returned ...
1
vote
1answer
555 views

NetCat ignoring (not sending) network data to broadcast addresses

If I run these NetCat below commands (no error messages at all) during a WireShark capture running (capture filter= udp dst port 4000) : luis@Zarzamoro:~$ echo "Hello" | nc -w1 -4u 255.255.255.255 ...
1
vote
1answer
548 views

grep not matching in nc output

I'm using nc to scan for open ports but I'm scanning a wide range and it's displaying too many results. Trying to grep it for the word "succeeded" doesn't work for some reason: $ nc -zv localhost ...