1
vote
2answers
82 views

What information is stored on the gap before the first partition?

Partitioning tools(for example fdisk) tend to leave a 2047 sector(LBA 1-2047, 1048064 bytes) between the MBR and first partition. On LBA 0 there is a MBR and from LBA 2048 starts the first partition. ...
2
votes
2answers
98 views

How does system know where the first logical disk starts?

I'm trying to understand the ms-dos partition table, and there's the following diagram: It comes from this site. Almost everything is pretty clear to me, but there's one thing I don't get. As you ...
2
votes
2answers
526 views

area on disk after the MBR and before the partition start-point

If I use a MBR partitioning scheme and create a primary or extended partition with fdisk(version 2.20.1), then it starts on sector 2048. If I remember correctly, then older versions of fdisk started ...
3
votes
1answer
108 views

How to detect if the FreeBSD disklabel is on the first sector of the disk?

I have attached a FreeBSD disk to my Linux machine. How to detect if the disklabel(aka bsdlabel) is on the first sector of the disk or the PC MBR is on the first sector of the disk and disklabel is ...
5
votes
2answers
820 views

Linux/GParted can see partition table but dd bs=512 count=1 can't

I have an MBR formatted sd card and when connect to a Linux machine (xubuntu 12.04) it can mount a partition and parse the file system (as can GParted). However, when I try to read the MBR from the ...
2
votes
1answer
402 views

fdisk, dd, and the Rapsberry pi

I was trying to wipe my 4GB SD card which acts as the hard drive for the Raspberry Pi, so I went into Mac OS X Disk Utility* and Erased the entire disk, and specified that the whole disk be one big ...
2
votes
2answers
118 views

Can I safely resize my partition from its beginning?

Currently dual booting Windows 8 and Linux Mint 14, sooner or later I will give more space to my Linux system. Is resizing my Linux partition from the beginning a safe operation ? If yes, could you ...
1
vote
2answers
789 views

Fdisk partition alignment, NAND, not showing specified heads

I ran fdisk with these options, fdisk -H 32 -S 32 /dev/sdc Then I made a new label, and created an aligned first partition. Disk /dev/sdc: 7743 MB, 7743995904 bytes 32 heads, 32 sectors/track, ...
1
vote
1answer
88 views

Location on disk to write a byte-flag?

I am writing an update utility for an embedded Linux device for which I am responsible. I'm creating a basic side-by-side setup, where updates are applied to a staging partition and then the ...