1
vote
1answer
34 views

Error compiling drivers for Ralink RT2870

Im trying to install drivers for a rosewill RNX-N600UBE wireless card (Ralink RT2870 chipset) on Kali Linux. I downloaded the drivers form their website and unpacked/unzipped them, but now when i try ...
0
votes
1answer
33 views

What is a master mode? [closed]

I want to know what's the difference between "master mode" and "managed mode" and the advantages of each one !
0
votes
0answers
35 views

Why does my USB device not get recognized by Ubuntu?

I seem to have a problem that no else appears to have encountered before (at least a couple of hours Googling has shown this to be the case). I am running Ubuntu 12.04. I plug in the device (Linksys ...
0
votes
1answer
110 views

get driver for dell wireless card

iam using laptop dell inspiron 15R 5537 ... using dell wireless card 1705 ... and wireless is not defined on any linux distro i tried (ubuntu , debian , elemetary OS luna , gentoo ) :( i searched ...
1
vote
0answers
73 views

I can't get any internet connection on Crunchbang, how can I download and manually install the drivers?

I recently installed crunchbang on my Lenovo G505 Laptop, it uses broadcom drivers and I can't get any type of connection. I have tried connecting it with an ethernet cable every way that I could and ...
2
votes
0answers
127 views

Periodically unable to connect to WPA2-EAP access point

I have setup a WPA2-EAP TLS WiFi access point at home and everything works fine usually. Unfortunately, though, many times I'll drop my connection to the access point and won't be able to reconnect. ...
1
vote
1answer
141 views

ath9k 802.11n 300Mbps at low speed

I'm testing my new home 802.11n network. router - slax 7, kernel 3.8.2, AR9382 mini pci-e (sparklan WPEA-121N) wlan0 IEEE 802.11abgn ESSID:"xyz" Mode:Ad-Hoc Frequency:2.412 GHz ...
1
vote
1answer
155 views

Install Drivers Offline Arch Linux

I have been attempting to install Arch Linux on my Macbook Pro but the wireless and ethernet drivers don't work. Because of this, I cannot access the internet on it. So whilst searching for a solution ...
0
votes
0answers
98 views

Atheros AR9485 not providing full 802.11n speed, Debian 7.3 (Verison MI424WR router)

I found this while searching around, but it didn't quite apply to my situation, I think. My household recently got Verison FiOS 75/35 and I thought everything would be alright, as my wireless NIC ...
1
vote
1answer
323 views

Fedora make command broken, kernel mismatch

On a new Dell Inspiron 3521, I tried installing Linux. First try was Ubuntu, but couldn't get the WiFi working. After trying all sort of things and commands, some errors started to show. I then ...
2
votes
1answer
792 views

Why does linux-based laptops have weak wifi signal in comparison to windows-based laptop?

I have faced this problem many times. First, I thought it has something to do with laptop model and brand but later I came to know that same hardware with different OS was having different results. ...
0
votes
1answer
1k views

hostapd, ath5k, nl80211 - how to get it working?

I have this network adapter in an Asus notebook running Manjaro Linux (based on Arch), everything up to date (Kernel: 3.10.11): > lspci -k | grep -A 3 -i "network" lspci: Unable to load libkmod ...
2
votes
0answers
496 views

How to turn my linux laptop into wireless repeater?

I need to use my laptop to extend the range of my wireless router. I have a Samsung laptop with FEdora19 installed (but those should be irrelevant for a good answer). My wireless card supports master ...
1
vote
1answer
76 views

Best way to find the active wireless device

Of course I know the command: iwconfig which lists devices (and gives info about whether they have a wireless connection). For the purposes of a shell script, I'm really wondering, is there any way ...
1
vote
0answers
80 views

AR9485 Wireless Network Adapter with Linux

Lately I change my VivoBook 500ca for Linux. I installed the latest Mint Cinnamon. I have been having some problems with my wireless card : description: Wireless interface product: AR9485 ...
1
vote
1answer
142 views

Connecting a wireless webcam and wireless dongle

I must create a wireless connection between a USB wireless dongle (DLink wireless-N USB Mini Adapter DWA-140) and a wireless webcam (DLink DCS-932L). I.e. point to point connection without Internet. ...
2
votes
3answers
498 views

Wireless on Slackware

Ok, so I finally got my wireless working on Slackware. Trouble is, I don't really understand what I'm doing. I'm currently root and in order to get wireless, I first have to: wpa_supplicant ...
1
vote
0answers
65 views

How to associate a seperate station to a Wifi AP

My Linux machine (A) is connected with some Wifi AP over my wireless device (wlan0). I want to give some other Linux machine (B), which is connected to me by ethernet (eth0), access to this network. I ...
2
votes
1answer
1k views

Set wi-fi power saving polling interval on Linux, is it possible?

man iwconfig states: power Used to manipulate power management scheme parameters and mode. To set the period between wake ups, enter period `value'. [...] Examples : ...
1
vote
2answers
933 views

Why is my wlan0 interface on Angstrom (Beagleboard) “Not Associated”?

I'm installing a Angstrom (custom build, not the default build) on a Beagleboard XM. I can scan for wireless networks using iwlist and see the neighborhood wireless devices. I have set my SSID and ...
2
votes
1answer
778 views

How to find speed of wlan interface?

I'm trying to find speed of network interface using file-descriptor. It's easy to do it for ethX, just calling cat /sys/class/net/eth0/speed. Unfortunately this method doesn't work with wireless ...
6
votes
2answers
795 views

wlan number assignment

How or where does Linux determine the assignment of a network device? Specifically, wlan0 or wlan1 for wireless USB devices. I plugged in a TP USB wireless a while ago, and it was assigned wlan0. I ...
0
votes
0answers
123 views

Can I run hostapd in a virtual machine hosted in a windows system?

I would like to know if it is possible to run any Linux/UNIX distribution with hostapd in a virtualized environment. My idea is to host a small virtual machine, which will use my Windows Host ...
0
votes
0answers
83 views

What could be the possible reasons for bad performance of TCP over Wireless or Sate-lite networks ?

I am running a wireless network having Linux(fedora 17) at sender end.We decided TCP_veno is most useful for my network,so we are using it as default congestion control algorithm.Still, We are not ...
0
votes
1answer
626 views

brcmsmac does not work

I am attempting to enable my wireless interface in Slax Linux, so far, I know the driver I need is brcmsmac, since I have a broadcom card; and this work in Slackware. The driver is available and does ...
0
votes
1answer
74 views

What are the other congestion control algorithms specially designed for lossy Wireless Networks like LTE and WiMax?

I am trying different congestion control algorithms for getting maximum throughput and minimum delay across my setup for TCP flow.Please suggest other available algorithms apart from Veno, ...
0
votes
1answer
192 views

will tinycore work with S110 wireless adapter?

will tinycore work out of the box with S110 lenovo netbook? Wireless is obviously the first issue to be encountered? can anybody report that it will work out ofthe box? or i will have to spend some ...
0
votes
1answer
2k views

Linksys AE3000 install on linux

I bought a Linksys AE3000 wireless adapter hoping I could use it on my Ubuntu 12.04 box. I found a website that walked through using it, but it didn't work. I edited rtusb_dev_id.c to add: and then ...
1
vote
1answer
1k views

How to monitor other nodes to get RSSI?

I need to measure RSSI between two peers of nodes in same network. If I have these two information: SSID for their network. IP for the target node to get the RSSI regarding it. So I found this ...
1
vote
3answers
2k views

iwlwifi error, then WLAN is very slow and can't see other WLANs

I have a wireless interface Intel 1030 on a Dell XPS 15 laptop. lspci says: 03:00.0 Network controller: Intel Corporation Centrino Wireless-N 1030 [Rainbow Peak] (rev 34) Recently I noticed that ...
0
votes
1answer
690 views

Can't connect to my wireless network though GNOME

I am a complete Linux beginner and I managed to install Archlinux today. But I have no access to my wifi for some reason. I get internet access in my terminal with wifi-menu but gnome tells me that ...
2
votes
1answer
198 views

Wireless on my Dell Latitude E5320 doesn't work on Ubuntu but works on Linux Mint. What can I do to make it work?

I have dualboot Ubuntu 12.10 & Linux Mint 14, both are clean install & updated with the latest. My wireless works flawlessly on Linux Mint but it's very unreliable on Ubuntu: every 15~20 ...
1
vote
2answers
665 views

Can connect to wireless router but can't browse internet

I have a Dell Studio 1450 running Fedora 17. I installed a new wireless router in the office recently. And everybody apart from me is able to connect to the internet via it. Google revealed ...
3
votes
1answer
2k views

Wireless problem with RTL8723 and Fedora 18: can't connect to a wpa2-secured network

I'm running Fedora 18 on a Toshiba laptop with the notorious RTL8723 wireless card. I've been able to compile the driver using lwfinger's instructions from this forum thread here wget ...
7
votes
1answer
1k views

Linux find Wifi Networks trotocol(a/b/g/n) version of all available access points

I do use iwlist wlan0 scanning and it gives me a fair amount of data, but one part is missing. It is protocol version. By protocol I mean (a/b/g/n). It would be very good to have these commands in ...
2
votes
2answers
4k views

Ralink RT5370 Wireless usb dongle not working

lsusb Bus 002 Device 014: ID 148f:5370 Ralink Technology, Corp. RT5370 Wireless Adapter uname -a Linux HOSTNAME 2.6.32-279.14.1.el6.x86_64 #1 SMP Tue Nov 6 11:21:14 CST 2012 x86_64 x86_64 x86_64 ...
3
votes
1answer
315 views

Kubuntu doesn't reconnect to Wifi after waking up from sleep

I just installed Kubuntu on my laptop and it's working fine so far, except the wireless connection is not switched on after waking up from sleep. I do have to click "Enable wireless" so that it ...
2
votes
1answer
296 views

Configuring Wireless Network

After a long struggle I finally seem to have installed the non-free wireless firmware for my wireless NIC. I'm trying to set up a file server, so I want to configure the network to be static. Would ...
7
votes
1answer
270 views

Installing USR 5422 on Ubuntu 12.04

I am a newbie to Linux. I was trying to set up the USR5422 USB adapter. It worked fine for the first time, but since then it freezes the computer most of the time. What commands can I fire to see ...
2
votes
2answers
4k views

Installing wireless driver (realtek 8188CE) on Debian wheezy

I had a hard time installing the wireless driver for my debian. My debian was Sqeeze but soon after I realized Wheezy was the one to support my wireless adapter, realtek 8188CE,I upgraded to wheezy. ...
2
votes
1answer
567 views

How to get list of available wireless networks without being root

I would like to get a list of all the wireless networks. iwlist wlan0 scan | grep ESSID This will only show me the wireless network I am currently connected to. When I run the command as root, it ...
0
votes
1answer
205 views

wlan is first brought to life when ethernet is plugged in

Endless timeouts... Request timed out. Request timed out. Request timed out. Request timed out. Request timed out. Reply from 192.168.1.11: bytes=32 time=105ms TTL=64 ...
4
votes
1answer
536 views

Start and stop bluetooth service automatically as rfkill switch changes

I would like to start / stop bluetooth service automatically when I turn on / off rfswitch, is that possible ?
8
votes
3answers
3k views

wireless is disabled by hardware switch even when not

I have a spartan computer. It has a built-in wireless module that up until recently I've had no issues with. The current problem is this. Everytime I shutdown the computer and it boots back up, I am ...
3
votes
2answers
221 views

Kernel 3.3.2-6.fc16.x86_64 broadcom wireless not appearing

I'm using kernel 3.3.2-6.fc16.x86_64 and I have a Broadcom 4312. When I run iwconfig, I get the following: lo no wireless extensions. p2p1 no wireless extensions. I cannot use ...
2
votes
2answers
375 views

How to install drivers on Linux

How can I install a driver on any Linux? I have XG-762 Sagem adapter on USB with the ZyDAS 1211B chipset, and I don't have drivers for it. What should I do? PS: Despite it should be in my file ...
1
vote
1answer
607 views

How to identify the wireless network card on my laptop?

bash-4.1# lspci 00:00.0 Host bridge: Intel Corporation Mobile PM965/GM965/GL960 Memory Controller Hub (rev 0c) 00:02.0 VGA compatible controller: Intel Corporation Mobile GM965/GL960 Integrated ...
1
vote
1answer
418 views

Linksys WAG200 DSL/Router combo with cable modem? [closed]

I have a Linksys DSL/Router combo. It was previously used for my DSL connection. I switched to a cable connection now, using Motorola cable modem. Is it possible to create have the cable connection ...
2
votes
2answers
2k views

Can't insert rt2800usb module: Invalid argument

I just got an ASUS N13 USB wireless dongle, and unfortunately it's not detected and I can't load it with modprobe: $ sudo modprobe rt2800usb WARNING: All config files need .conf: ...
-1
votes
1answer
85 views

Linux 3.x: what wireless chipsets will support a bridged connection?

I have asked a similar question on the Ubuntu pages but this is likely a generic Linux issue: what variety of wireless cards/drivers will support being placed in a bridged connection? I have been ...