1
vote
2answers
1k views

Can't access ssh in my VM Centos

My Cento's IP is diferent of the normal. And I cant access it in a ssh command And when I tried access using ssh noting I want to use ssh and samba client, but my IP is diferent. And I have ...
0
votes
1answer
62 views

host only ip address: can it be 10.*.*.*?

My router is set to have computers IP range from 10.1.1.1 to 10.1.1.60 I'm trying to run Linux in virtual box in a host computer with windows 7. The host computer has 10.1.1.5 currently, which is ...
2
votes
1answer
111 views

Share an external IP with several virtual hosts

For a centos server hosting a few LAMP virtual machines (using VirtualBox), I have a single external IP. I would like to be able to use this single host external IP to address the virtual machines. ...
2
votes
1answer
2k views

Virtualbox NAT + Host-Only Adapter

My host is Ubuntu 12.04 and guest is a Debian squeeze (LAMP server). I want to allow the host to connect the guest. and allow the guest to connect the internet. The guest should not be enabled from ...
0
votes
3answers
496 views

Fedora 18 host cannot ping Windows XP guest

I have my laptop running Fedora 18. I want to run a Windows XP guest using VirtualBox 4.2.6. My configuration seems correct, here is my networking report. Fedora 18 host lo: ...
2
votes
1answer
57 views

switch network on and off of a virtual remote server

I need to perform a testing panel which disconnects a network cable and connect it again on a specific virtual server via a php web page. I found that ip & ifconfig can disconnect a network, but ...
1
vote
2answers
6k views

Configure a bridged Ethernet adapter in a VirtualBox guest running Scientific Linux

I installed Scientific Linux 6.2 x86 in VirtualBox on Windows 7 x64. The adapter is Adapter 1: Paravirtualized Network (Bridged adapter, Marvell Yukon 88E8056 PCI-E Gigabit Ethernet Controller) ...
8
votes
3answers
15k views

Why are my two virtual machines getting the same IP address?

I have two virtual machines both running on a Linux host (Fedora 16). I set both adapters as attached to NAT. When I boot them up they both have their default gateway set to 10.0.2.2. They also ...