1
vote
1answer
54 views

Debian server doesn't show in DHCP list on router

I have a Raspberry Pi running Raspbian which is connected over ethernet to my router. The router has been running both with DCHP and Static IP addresses and over the local LAN I can connect fine over ...
2
votes
1answer
182 views

is it possible for DHCP to assign different IP addresses to the same machine?

I have install and configure a DHCP server on my centos6.5, it works properly and assign IPs to the clients Machines in my Network, and As I noticed when a client reconnect the dhcp reassign the IP ...
0
votes
1answer
352 views

How to request a specific IP address from DHCP server?

I'm running Angstrom Linux on an embedded device (BeagleBoard-xM). I managed wireless connection via a Wi-Fi adapter. When I load its driver using modprobe, BB-xM requests an IP address from router ...
1
vote
0answers
62 views

What should be the right dhcp configuration for generating a new network over eth0?

Even not under a real server like scenario, I'm testing with dhcpd for learning and practice purposes. I'm using Ubuntu 12.04 LTS. I want to offer a network by my eth0 interface. I receive ip and so ...
2
votes
2answers
437 views

keep losing IP with dhcpcd

I have an Arch Linux install in a VirtualBox VM, and as I'm working all of a sudden, it will lose it's dynamic IP address. When this happens, if I check on the status of the dhcpcd service it says ...
4
votes
1answer
1k views

Can't ssh to beaglebone?

After I did: route add default gw 192.168.7.1 I also changed /etc/resolv.conf: nameserver 192.168.7.1 in order to share internet between Ubuntu in VMware. I've got internet working but after a ...
2
votes
1answer
482 views

What is the simplest way to connect to wireless on a Debian system with nothing but essential?

I have a Debian Jessie system which, for reasons unrelated to this question, has nothing installed but the set of essential system packages. What is the simplest method for connecting to a wireless ...
3
votes
1answer
511 views

set VM IP address to be the same every time from DHCP on CentOS 5.6

I have an issue where, each time I start my CentOS 5.6 VM, DHCP (I believe) is allocating my VM a different IP. I have the VM mapped as a Samba share in Windows 7 and this changes between 192.168.0.8, ...
2
votes
1answer
2k views

u-boot disable DHCP requests with setenv

I am trying to disable the DHCP requests after the Kernel was loaded. Using freescale imx25 dev-board in standard config. In u-boot, I find two lines ip=dhcp: MX25 U-Boot > pri bootdelay=3 ...
8
votes
3answers
12k views

How to find out if Ubuntu is using DHCP (Ubuntu 12.04 LTS GUI)

How can I find out if my IP address is DHCP, Fixed or Dynamic? I need to tell my network administrator what the IP address is, that my Virtual Machine is using. I know the numbers, but I don't know ...
8
votes
3answers
14k views

Why are my two virtual machines getting the same IP address?

I have two virtual machines both running on a Linux host (Fedora 16). I set both adapters as attached to NAT. When I boot them up they both have their default gateway set to 10.0.2.2. They also ...
4
votes
2answers
741 views

How to configure Linux to use DHCP or static IP depending on presence/absence of DHCP server?

I would like to configure a network interface to make use of DHCP if a DHCP server is present on the network during boot, but otherwise default to some default static IP address.
2
votes
1answer
565 views

Is it possible to use Internet Connection Sharing with DHCP?

I know it is possible to share an internet connection with another pc using ip-forwarding and masquerade. Is it possible to set up the sharing computer as a DHCP server, so the settings (ip, gateway, ...
4
votes
1answer
1k views

Two IP addresses assigned to the same machine?

I seem to be using two IP addresses on my PC. I use DHCP to get an IP address and then I statically set an IP address and activate it. ifconfig says that I am using the address given by DHCP but I am ...