2
votes
1answer
67 views

What Did Users Do or Use Before the Make Command?

I use Gentoo as my primary home Desktop OS. I have since ~2004. I appreciate the emerge command for managing a source based OS as well as it does. Every now and then I check on other distributions, ...
0
votes
0answers
80 views

Emerge freezes on raspberry pi without error message

I am trying to install raspberrypi-userland to my gentoo system with the command emerge --ask raspberrypi-userland on my raspberry pi. I am well aware that without cross-compile environment this ...
2
votes
1answer
142 views

Why is =sys-libs/glibc-2.16's --enable-kernel is ignored on Gentoo Linux?

I'm trying to build eglibc support for old kernels, 2.6.9 in this case. So I set NPTL_KERNEL_VER in make.conf, and during configuration phrase I can see the --enable-kernel=2.6.9 parameter But this ...
3
votes
1answer
988 views

VDPAU library not found

I want to try this VAAPI backend for VDPAU. I have compiled mplayer with vdpau in Gentoo Linux (amd64) but I get this error: Failed to open VDPAU backend libvdpau_nvidia.so: cannot open shared object ...
1
vote
1answer
372 views

Gentoo how to compile LVM statically linked?

A Gentoo install still in the livecd stage (unable to boot so far) fails to emerge LVM statically. I need a statically compiled lvm in order to use it in my initrd. My make.conf: CFLAGS="-O2 ...
1
vote
2answers
403 views

Can't compile kernel in gentoo

I installed gentoo by the handbook from official site. When I got into the step 7.b. Installing the Sources, the book says: Code Listing 2.2: Viewing the kernel source symlink When you take ...
3
votes
3answers
476 views

Present USE flags upon emerging a package in gentoo

I was wondering if there are any tools to present the compile time options/ flags of a package in Gentoo when emerging. I am referring to something like this
3
votes
0answers
182 views

target/build CFLAGS mixup when cross-emerging due to bug or my stupidity?

I'm trying to emerge LLVM using emerge from a crossdev (for ARM) overlay in Gentoo. I've set the CFLAG of the overlay to optimise for arm (-march=armv6j), which seems to make ./configure fail on the ...
1
vote
1answer
2k views

How to increase Xen guest CPU utilization?

My Xen dom0 is a Gentoo x64 pvops. I boot my guest Gentoo, in PV mode, system with the same kernel my dom0 uses. When I emerge in the guest system, building a CPP package, I am experiencing low CPU ...
7
votes
2answers
3k views

On Gentoo, how do I rebuild all packages depended on some other package?

I made mistake and changed perl non-threaded version to threaded by unmerge first, change USE flags to include ithreads and emerge perl again. Now most packages depending on perl are broken. How do I ...
1
vote
1answer
228 views

Changes for py2cairo ebuild to activate xpyb in build

I would like to build qtile for Funtoo/Gentoo and there is also a nice py2cairo ebuild, but it misses an option for xpyb, so it builds without those options, now my interesst is to fork that ebuild ...
2
votes
1answer
745 views

Where is CONFIG_COMPAT_VDSO in make menuconfig?

I'm trying to compile a Linux Kernel to run light and paravirtualized on XenServer 5.6 fp1. I'm using the guide given here: ...