0
votes
0answers
93 views

Nvidia ethernet port not detected on Centos 7

When I tried to install Centos 7, my Nvidia ethernet port was not detected during the installation, whereas in all other distros it works perfectly without any problem. My rig is an AMD Athlon x2 64 ...
0
votes
3answers
84 views

Data transfer between Ubuntu and CentOS [duplicate]

How do I transfer data between Ubuntu and CentOS using LAN cable, in the same network? I tried installing Samba which did not go well in CentOS.
1
vote
1answer
2k views

Problem compiling a driver : “No rule to make target”

First of all I am running a CentOS 6.4 installation. My computer is a laptop and I am trying to install the drivers for my ethernet card, because this week end I lost my ability to connect to the ...
1
vote
3answers
1k views

Virtual Interface Not Showing up in ifconfig?

I am trying to create a virtual interface for the purpose of NameBased Virtual Hosting on my CentOS linux box; please find below is the devices' information:- DEVICE=eth0 BOOTPROTO=dhcp ...
1
vote
0answers
884 views

Unable to install Atheros AR8161 Ethernet controller driver for centOS 6

I've installed CentOS 6.3. However, eth0 does not show up on ifconfig. So I figured out that I need to install alx Ethernet driver from here. Since my internet is not working, as ethernet drivers are ...
8
votes
2answers
1k views

How can I disable TCP/IP for an Ethernet adapter?

I have CentOS 6.3 running in a (virtual) machine with two Ethernet adapters. I have eth0 connected to a TCP/IP LAN and eth1 connected to a DSL modem. The system is intended as a dedicated ...
4
votes
3answers
13k views

CentOS 6.3 Device eth0 does not seem to be present (Minimal non-cloned setup)

I installed CentOS 6.3 on my hardrive partition (new install...minimal install). After successful installation, I see that eth0 was down looked for 70-persistent-net.rules file under /etc/udev .. ...
1
vote
1answer
1k views

Network Interface Names output from ifconfig

So this has been driving me nuts for a good couple of hours, so I thought I'd ask about it here (let me know if there's a better forum for this question). I have a CentOS Virtual Machine on ESXi. I ...
4
votes
2answers
4k views

How do I configure which ethernet connections are active on boot?

I have an unmanaged dedicated server that I administer, running CentOS. Recently when I reboot the server, I am unable to use SSH. Both times this has happened the server host has determined the issue ...