3
votes
1answer
226 views

Which TCP congestion control algorithm is best for low speed radio modems?

On my project we have remote Linux nodes that communicate over the Internet via very low speed CDMA cell modems. The bandwidth on these modems is about 2kbyte/second and the RTT back to the server is ...
3
votes
1answer
86 views

Why doesn't 'ar' work like the manpage says?

I'm trying to use 'ar' included in Debian Wheezy armel version of binutils and it doesn't seem to operate like on other systems I've encountered. Some sample output from the command-line: $ ar ...
3
votes
1answer
47 views

How to determine how many bytes / hr are being written to my SD card

I have a Debian embedded Linux system that uses an SD card as the RFS. What is a reliable way to determine how many bytes / hr are being written to the SD card?
1
vote
1answer
182 views

High RX packet error count with modem - how to analyze?

I'm testing a CDMA modem on my Debian embedded Linux system. I'm doing some wgets of large files and am seeing the connection drop now and then. Looking at the ifconfig output for the PPP interface ...
0
votes
0answers
95 views

optimizing Debian wheezy for an embedded board

I have Debian 7.1 on an embedded board that I just use WiFi interface, openVPN, and run a C code. The code uses UDP socket to transfer data, and do some calculations and output some signal on GPIO. ...
2
votes
1answer
434 views

How to custom build debian's busybox?

I'm building an embedded system based on debian 7, and I'd like to make the most out of busybox that comes with debian. The problem is default busybox build in debian seems quite minimal, for example ...
0
votes
1answer
105 views

How to create a debian 3.x kernel rootfs on a 2.x host

I'm trying to build a rootfs for an embedded A10 board. This will be matched up against 3.0.62+ modules and a corresponding vmlinux image. I've been trying for a few days to get a rootfs set up for ...
2
votes
1answer
228 views

Alix Board write performance

I have an alix board on which I have installed debian4alix (sqeeze). After using it for a while I noticed that the write performance of the board was pretty low. I ran the following test: dd ...
7
votes
1answer
3k views

Running Debian i386 binary on Debian armel via qemu

I am trying to follow this guide to set up a Ventrilo server on my SheevaPlug, running Debian armel. This page states that I can use QEMU to run the binary that was made for i386 on my arm system. ...