The tag has no usage guidance.

learn more… | top users | synonyms

0
votes
1answer
152 views

WiFi frequently drops, suspected driver issue

I'm running a fully up-to-date Fedora on a Macbook Pro. To get WiFi working in the first place, I installed akmods-wl as recommended. The WiFi works, but the connection keeps dropping. I've noticed ...
0
votes
0answers
219 views

Problem with creating WiFi Hotspot in Fedora 20

I have a very strange problem in creating a WiFi hot spot. I bought a Dell laptop recently and installed Fedora 20 on it. I installed my WiFi drives by following the instructions on this page: Wifi ...
0
votes
0answers
531 views

Install wifi driver for Macbook 11.1 under Tails

I am having some troubles with the WIFI on my Macbook using Tails (USB). I encountered a problem similar once when setting up an Arch Linux USB system but I as able to find the necessary drivers and ...
0
votes
1answer
2k views

Broadcom BCM4352 Wifi + Fedora 22 + kernel 4.0.4-303

~ lspci | grep -i broadcom 02:00.0 Network controller: Broadcom Corporation BCM4352 802.11ac Wireless Network Adapter (rev 03) ~ rpm -qa |grep -- -wl kmod-wl-6.30.223.248-8.fc22.1.x86_64 ...
0
votes
0answers
66 views

wifi-menu leads to freezes in Arch

I have a Macbook Pro 5,1 that I recently installed Arch on. Today, I had problems with my wifi, so I reinstalled the broadcom drivers, and was able to get wifi-menu working, but this has led my ...
0
votes
0answers
147 views

Why can't my Debian received much wifi-signal

My wireless connection is always broken, and it can't receive good signal. I am not sure if the wireless driver caused it. Is my wireless driver too old? Or there are some other reasons? My mobile can ...
0
votes
0answers
276 views

Install b43 firmware from Arch Install Media

I'm currently attempting to install Arch on my dual booted Linux box, however my system uses b43 which I have and used post-install on Mint and Ubuntu. I'm not sure how to run makepkg from the Arch ...
0
votes
0answers
186 views

extending wifi scan list to 2.3GHz and 10MHz width

How to extend wifi frequency scan list to be able to connect 2.3GHz or 2.5GHz access points? And how to set channel width to 10MHz? Arch Linux. Broadcom and Atheros drivers.
0
votes
0answers
966 views

Install BCM 4365 drivers in Backtrack 5R3

I have recently installed Backtrack 5 R3. When I try to run: sudo apt-get install bcmwl-kernel-source I get the following error: Error! Bad return status for module build on kernel: 3.2.6 (x86_64) ...
0
votes
1answer
2k views

brcmsmac does not work

I am attempting to enable my wireless interface in Slax Linux, so far, I know the driver I need is brcmsmac, since I have a broadcom card; and this work in Slackware. The driver is available and does ...
0
votes
1answer
63 views

Broadcom NIC support on FreeBSD 8.3

I'd like to know if the following network cards are supported: Broadcom netxtreme II 1000 express dual port ethernet adapter Broadcom netxtreme II 1000 express quad port ethernet adapter ...
-1
votes
1answer
2k views

Unable to monitor mode and injection work on my wifi card bcm43142

I have dual booted my laptop with kali Linux. After working on it somehow I managed to get work my Wi-Fi. But I'm unable to start monitor mode and injection. When I execute airmon-ng start eth1 it ...
-1
votes
1answer
14 views

Cannot install driver for BCM4312 with Fedora 23, no internet connection

I have installed fedora 23 and have dual boot with Windows 10 on Dell Inspiron 1545. The system doesn't recognize the wireless card with is Broadcom BCM4312. I downloaded several rpms and tried to ...