3
votes
2answers
205 views

GNOME doesn't work on Debian Jessie after installing fglrx

I'm using 64bit Debian Jessie and followed these instruction to install fglrx for Radeon HD 7000 series: https://wiki.debian.org/ATIProprietary However GNOME doesn't work after it. I installed ...
0
votes
0answers
558 views

How to setup ATI/Intel dual graphics-card driver in Debian

I have searched it from the Internet, but there is only a solution for Ubuntu. Visit: http://xpressrazor.wordpress.com/2013/01/13/how-to-setup-amdintel-hybrid-graphics-cards-in-linux-ubuntu/ I ...
4
votes
3answers
2k views

GNOME 3 fails to load (old ATI graphic card driver problem)

I'm delighted to find this version of StackExchange as I normally lurk in the GIS board. I would greatly appreciate help with the following problem (which seems to be quite common - but I am just ...
0
votes
1answer
1k views

Debian 6 Gnome black screen after boot

I installed Debian a few weeks ago, and the last time I ran apt-get update, I think it updated something xorg/xserver, not sure. Since then i get a black screen after boot. If I go into recovery mode ...
4
votes
1answer
570 views

Second monitor detected but not receiving signal?

I'm at my wit's end trying to figure this one out. I have an ATI Radeon X1600 (DMS-59 connector with DMS-59 to dual-DVI adapter). I'm trying to get dual monitors working properly. So far, I've tried ...
0
votes
1answer
177 views

Debian Squeeze on HP Pavilion d7 with Sandy Bridge and ATI 6740 - display problems

After a fresh install of Debian Squeeze 6.0.7 on an HP Pavilion d7 laptop - the option to install the laptop packages was checked on the installer - the monitor was not recognized on ...
0
votes
1answer
7k views

How to configure FOSS ATI drivers on Debian Wheezy and ATI RS880 [Radeon HD 4250]?

Installed a fresh Debian Wheezy to enjoy Gnome 3 but it starts in fallback mode. I suppose that's because the loaded drivers do not support 3D acceleration. Installed packages I know are relevant: ...