Take the 2-minute tour ×
Unix & Linux Stack Exchange is a question and answer site for users of Linux, FreeBSD and other Un*x-like operating systems.. It's 100% free, no registration required.

I have a home server (with slackware 13) with a eth0 for the local network and a eth1 for the internet (cable modem with dynamic ip).

While I do want to learn more about iptables I am still on the proccess and I need some rules done and can't until a learn to do it as I dont wish my server to get compromised at this stage.

I currently have a vm where I play with my rules and everything and would appreciate if some one could wrap me a firewall rule for iptables to do the below:

  1. Allow all users from my dhcp server on eth0 to have full access to internet and server, in other words eth0 should have no restrictions within the network and server.
  2. Allow all users to be able to create a server, for example if they are playing a game such as for example warcraft, and they create a game, the firewall should allow the negotiation of those connections to go thru.
  3. Block any requests from internet to server unless it was initiated by the server or an users from the network.
share|improve this question

2 Answers 2

up vote 4 down vote accepted

So, basically your Linux box acts as a firewall?

First, enable IP forwarding.

echo 1 > /proc/sys/net/ipv4/ip_forward
echo 1 > /proc/sys/net/ipv4/conf/all/forwarding

Then, add some forwarding rules:

iptables -A FORWARD -i eth0 -j ACCEPT
iptables -A FORWARD -m state --state ESTABLISHED,RELATED -j ACCEPT

Secure the FORWARD chain:

iptables -P FORWARD DROP

Create a NAT rule:

iptables -t nat -A POSTROUTING -o eth1 -j MASQUERADE

Finally, don't forget to check that you have a default route:

ip route show | grep default

You should see something like:

default via <IP_of_eth1's_gateway> dev eth1

If not, add one:

ip route add default vie <IP_of_eth1's_gateway> dev eth1

(Usually the DHCP client will automatically add one)

share|improve this answer
    
thanks for the answer, I had already done the masquerade, and forwarding steps, and dhcpcd had alreay added the route as you said so now I am testing the forward on eth0, thanks. –  Prix Mar 23 '11 at 15:30

For allowing servers, you can manually add port-forward rules, or use a uPnP daemon (if the applications support uPnP - many do...) [linux-igd][1] should do that...

NAT-PMP is similar and used by some other applications. An implementation for Linux is here.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.