Take the 2-minute tour ×
Unix & Linux Stack Exchange is a question and answer site for users of Linux, FreeBSD and other Un*x-like operating systems.. It's 100% free, no registration required.

I recently got a RPi with different modules. One of them was a Connect2 Pi wireless dongle from LPRS, used to send 100 Mb data packages over the internet. It's basically an internet dongle. However, it does not work. According to the LPRS staff the drivers required for the dongle should be installed when you plug it in. However it doesn't do that.

I wonder what my mistake is and how to fix it (if it is fixable).

share|improve this question
    
Do you know which chipset the dongle uses? –  Renan Dec 27 '12 at 19:25
    
What distro are you running on the RPi? –  Ignacio Vazquez-Abrams Dec 27 '12 at 19:44
add comment

1 Answer

The dongle is likely not to work if plugged directly into the pi - the pi's USB ports provide very little power, and you have to use a high quality powered USB hub - I found that I have to do this even for using a wireless keyboard and flash drive at the same time (using one of these alone and its ok though). See here for a list of verified hubs that work. Believe me cheap ones don't work.

share|improve this answer
    
Yeah I know! However this is a dongle specially designed for raspberry-pi and should work in the raspberry pi's usb ports. However I have tried with a powered usb hub and it doesn't work. This is the website for this dongle link and yes, I know it's not a wifi dongle! –  Dramentiaras Dec 28 '12 at 9:08
    
If you're certain that was a verified usb hub, then it may be the distribution or kernel you are using. –  Drake Clarris Dec 28 '12 at 14:28
    
What power supply are you using? The pi alone uses 700 mA, and anything over that on the power supply is then supposedly used for USB power through the ports. A typical smart phone charger is 1A, and that left over 300 mA would barely be enough for a wireless dongle, and that's if that entire 300mA reaches the dongle (not likely). –  Drake Clarris Dec 28 '12 at 14:30
    
Hadn't heard of this device, so I looked it up finally - shows a power draw of 35 mA so it should work fine. Are you sure it's not working in the pi, or is it the other end that's not working? Is the other end in your PC? –  Drake Clarris Dec 28 '12 at 14:45
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.