Take the 2-minute tour ×
Unix & Linux Stack Exchange is a question and answer site for users of Linux, FreeBSD and other Un*x-like operating systems.. It's 100% free, no registration required.

I am writing a program using the framebuffer device directly and I have three problems there.

1) The only way I can set the screen resolution correct is by passing the kernel option during boot:

video=800x600

when using others like:

video=vesafb:800x600-32,ywrap ,

video=uvesafb:800x600-32,ywrap ,

video=intelfb:800x600-32,ywrap

the framebuffer is 800x600 in the terminal, but as soon as i start the program the resolution goes back to its native resolution (1366x768). Is this an Intel (gma) issue or am I doing something wrong here?

2) With all four above variants I am not able to acquire offscreen buffers. In example doubling the y-resolution via FBIOPUT_VSCREENINFO. Is there another option to be set to be able to use offscreen framebuffer memory? May be related to the above issue?

3) Exiting the program I am stuck on the framebuffer, even though the program cleans up and resets the old configuration. I have to go to another terminal by CTRL+ALT+F1 and back by CTRL+ALT+F7 to get back into X. Why could this be, assuming the program does everything correct?

I am on an Intel GMA 3150.

share|improve this question

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Browse other questions tagged or ask your own question.