Take the 2-minute tour ×
Unix & Linux Stack Exchange is a question and answer site for users of Linux, FreeBSD and other Un*x-like operating systems.. It's 100% free, no registration required.

I switched the second GPU in one of our servers (Ubuntu 12.04.1 LTS). But now lspci only gives one entry:

$lspci | grep -i nvidia
04:00.0 VGA compatible controller: NVIDIA Corporation G94 [Quadro FX 1800] (rev a1)

I already executed sudo update-pciids and re-installed the nvidia dev driver. What other steps can I do?

share|improve this question
    
Why does a server need two graphics cards? –  jordanm Dec 4 '12 at 15:08
2  
for GPGPU Computing aka CUDA and OpenCL –  Framester Dec 4 '12 at 15:16
    
@Framester How about output of lspci | grep -i vga? –  Karlson Dec 4 '12 at 16:09
3  
Are you sure this isn't a hardware issue? E.g., is the card fully seated, does the card work, does the slot, did you plug in the power connector... ? –  derobert Dec 4 '12 at 16:21
    
Is the second on-board or another discrete PCB? If it is on-board, it probably disabled itself. –  Aaron D. Marasco Dec 5 '12 at 0:35
show 2 more comments

1 Answer 1

up vote 2 down vote accepted

Could be a hardware issue: The card isn't fully seated, you didn't plug in a cable (power, etc.), the card is defective, the slot is defective, there is some dust in the slot.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.