Take the 2-minute tour ×
Unix & Linux Stack Exchange is a question and answer site for users of Linux, FreeBSD and other Un*x-like operating systems.. It's 100% free, no registration required.

I have a Linux 2.6 box that uses ifplugd to bring up the network. While initialising, the logs say, "Initialisation complete. Link beat not detected." and then it goes into releasing the present address and obtaining lease all over again.

My question therefore would be:

  • What is link beat?
  • What does it mean if a link beat is not detected?
  • Why is this so critical? What determines if a link beat is present or not?
share|improve this question
add comment

1 Answer

Link beat is a signal generated by ports on ethernet hubs and switches; it allows your network card to detect/negotiate the speed of the connection and to verify that the connection is healthy. If the card cannot detect the beat, it assumes the connection is faulty and retries.

  • Test your cable to see if it is functioning (or try a new cable).
  • Try connecting a different box to the same switch using the same cable.

This may help you identify the point of failure.

share|improve this answer
    
Still unclear about what causes "link beat"... Is thus some kind of crystal/oscillator in the network equipment? How is the beat detected? Is link beat a signalling protocol? –  Arpith Oct 30 '12 at 13:14
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.