Take the 2-minute tour ×
Unix & Linux Stack Exchange is a question and answer site for users of Linux, FreeBSD and other Un*x-like operating systems.. It's 100% free, no registration required.

Looking for an inexpensive embedded device that contains 2 Ethernet Ports, runs Linux (or some other type of Unix), and is under $50.

My main concern is cost. It must be under $50 and have 2 Ethernet ports.

It can be a bare circuit board, it doesn't need to be a complete device with cover and all.

share|improve this question

closed as primarily opinion-based by jasonwryan, slm, Anthon, Mat, manatwork Aug 12 '13 at 6:30

Many good questions generate some degree of opinion based on expert experience, but answers to this question will tend to be almost entirely based on opinions, rather than facts, references, or specific expertise.If this question can be reworded to fit the rules in the help center, please edit the question.

add comment

5 Answers 5

up vote 1 down vote accepted

http://soekris.com/

Not at the $50 level, but probably what you're looking for in general.

share|improve this answer
    
That is quite nice but above $60 I cannot possibly use these in my project. I'll need about 2000 of them and customers won't be willing to pay about above $80 total. –  unixman83 Mar 28 '12 at 15:24
2  
@unixman83 You said you "cannot possibly use these" and then accepted the answer? –  Michael Mrozek Aug 15 '12 at 14:51
add comment

I suggest looking at OpenWRT's Table of Hardware finding a supported router that is on that list that you can buy for less than $50 and then flashing the firmware with OpenWRT (Tomato and DD-WRT likely have similar lists )

share|improve this answer
add comment

Buy a Raspberry Pi and a usb Ethernet adapter ( they are about $5-$10 ) [ now you will have double ethernet ] so it will be lower than $50

share|improve this answer
add comment

You could try using a Raspberry Pi (http://www.raspberrypi.org/)

It only has one ethernet port, but at half your specified price, you could purchase 2 to get the double ethernet port, effectively doubling the power of the system.

share|improve this answer
    
However, if you're looking to sell something to customers, you might want to get a specialised PCB to fit your requirements. –  IntrepidBrit Aug 15 '12 at 8:46
2  
Related SE site : raspberrypi.stackexchange.com –  Grzegorz Wierzowiecki Aug 15 '12 at 9:03
add comment

Dlink or linksys with debian. minix also.!

share|improve this answer
add comment

Not the answer you're looking for? Browse other questions tagged or ask your own question.