Take the 2-minute tour ×
Unix & Linux Stack Exchange is a question and answer site for users of Linux, FreeBSD and other Un*x-like operating systems.. It's 100% free, no registration required.

I installed at fedora snmpd package...

> view    systemview    included  
> .1.3.6.1.2.1.1 view    systemview   
> included   .1.3.6.1.2.1.25.1.1 view   
> all          included   .1 80
> ####
> # Finally, grant the group read-only access to the systemview view.
> 
> #       group          context sec.model sec.level prefix read  
> write  notif access  notConfigGroup ""
> any       noauth    exact  systemview
> none none access  notConfigGroup ""   
> any       noauth    exact  all  none
> none

I could get only system information.... using snmpwalk or whatever..

I tried adding RFC 1213 1.3.6.1.2.11 snmp node with no luck....
What am i doing wrong?

share|improve this question

1 Answer 1

up vote 2 down vote accepted

The default fedora config is designed to only let you see the system group for security purposes. You need to replace the config with a better set that lets you access everything on the device. Running snmpconf -g basic_setup can help you with getting started. Or, you can replace the file with the following snippet (based on the above, I believe you aren't using SNMPv3 and only using the insecure SNMPv1 or SNMPv2c, so this is designed for that):

rocommunity ChoseACommunity

Make sure you set ChooseACommunity to something uniquely yours.

share|improve this answer
    
thank you.. it was configuration problem :( didnt know.. –  Parhs Jun 22 '11 at 16:16

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.