Take the 2-minute tour ×
Unix & Linux Stack Exchange is a question and answer site for users of Linux, FreeBSD and other Un*x-like operating systems.. It's 100% free, no registration required.

i am trying to write a device driver for my gps module. somehow the linux os when loaded to my arm board have /dev directory read only. when i try to do a "vi /dev/gps" it says file is read only.

due to this reason my application program can't open the /dev/gps.

Anybody know what is the problem here. May be i am too vague.

share|improve this question

migrated from electronics.stackexchange.com Apr 4 '11 at 12:20

This question came from our site for electronics and electrical engineering professionals, students, and enthusiasts.

2  
You are doing this as root, right? What is the output of mount? –  Faheem Mitha Apr 4 '11 at 15:37
    
Have you mounted devfs yet? Do you run a with a read-only root filesystem? Why on earth are you trying to run an editor on the device file? –  Gilles Apr 4 '11 at 18:42
1  
You can't run a text editor against a character device. You might be able to run it against a block device like /dev/fd0 as I have done in the past, but that will read in the whole block device (floppy in this case) into memory and the text editor may still have issues reading/writing. For a character device, try using cat to monitor it's output. That works with my GPS. –  penguin359 Apr 6 '11 at 4:07
1  
Also, post the output of id, ls -l /dev/gps, and ls -lL /dev/gps if you can. –  penguin359 Apr 6 '11 at 4:09

1 Answer 1

Running ls -l /dev/gps will show you the actual permissions on the device file (probably not read-only).

Seeing as this is in fact a device file, you won't be able to open it in a text editor (for obvious reasons).

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.